SGI Octane/Octane2 (IP30) Netboot Kernel

	ip30-r10k-impact-5021-nb   - Boots SGI Octane R10000 w/ Impact
	ip30-r10k-odyssey-5021-nb  - Boots SGI Octane R10000 w/ Odyssey
	ip30-r12k-impact-5021-nb   - Boots SGI Octane R12k/R14k w/ Impact
	ip30-r12k-odyssey-5021-nb  - Boots SGI Octane R12k/R14k w/ Odyssey

	Kernel Version: 5.0.21

	Supported Filesystems:
		Ext2/3/4
		ISO9660
		NFSv3/v4
		UDF
		XFS

>>> How to boot on serial console:
	bootp(): console=ttyS0,<baud rate>
		where <baud rate> is usually 9600 for most machines, unless
		changed by editing the 'dbaud' parameter in the PROM Monitor.
		38400 is the maximum baud rate.

>>> How to boot on framebuffer:
	bootp(): console=tty0

NOTES:
  - RAM is limited to 2GB.  Remove any extra RAM beyond this amount to avoid
    issues.

  - Only machines WITH a graphics board installed will work.  Even if you
    intend to run serial-console only, you must have either an Impact or
    Odyssey graphics board installed for these kernels to boot.